DoubleStep Ultralight

(1 customer review)



Ultralight DoubleStep for making the ultimate DIY climbing sticks for hunting. Many also upgrade Lone Wolf sticks with these DoubleSteps, especially on the top step to be able to comfortably reach higher to place next stick.

Using on Lone Wolf sticks will require a replacement bolt. Use 1/4″-20 x 2″, Grade 8. Might be able to get at your local hardware store or available here – Replacement bolt for Lone Wolf Stick. Note – you only need a replacement bolt at the top and bottom, not middle step. Be sure to re-use the plastic washer under the bolt head to prevent the rotating LW standoff from loosening your DoubleStep.

SKU: N/A Category: Tags: , ,


New Ultralight DoubleSteps available in straight or angled. These are 9″ wide, 1.5″ high (2″ high for angled), and 3/8″ thick. There is a 1/4″ hole for the bolt with a 1″ channel on the back to hold tight to the 1″ aluminum tube. There are also recessed pockets to reduce the weight. These work on DIY sticks, Lone Wolfs, and any other brand of climbing sticks that utilize a 1″ tube.

These are made from 6061 aluminum.

Straight weigh a mere 2.7 ounces. Angled weigh 2.8 ounces.

Disclaimer – Use at your own risk. DoubleSteps will not be liable for any injury or death that occurs from using our products. There is inherent risk associated with DIY projects and with climbing. Since we cannot control how these are attached or used, we cannot be held liable.

Additional information

Weight 2.7 oz
Dimensions 9 × .375 × 1.5 in

Anodized, Non anodized, Camo Dipped, Anodized Blemished


Straight, Angled

1 review for DoubleStep Ultralight

  1. Jeff Worster (verified owner)

    Ordered these to replace on my novel minis and was going to be my first time using a double step and WOW. These really lightened up my setup, mad changing my stand much easier and best of all the quick shipping and customer service has been awesome. I will say (to no fault of EWO) there is a little bit of “wiggle on my novel tubed but that is because the tube tolerances are not as exact as EWO machining, a little Camo form under it and it tightened up right away. Thanks EWO!

Add a review